Fast male jack power connector
This accessory allows you to add a male jack power connector to a cut piece of LED tape. It is very useful if you happen to have to connect two monochrome LED strips amongst themselves. This is possible because each of our LED tapes is equipped with a female jack power connector at the end. No need for welding.
How to use this connector:
Open the small valve at the end of the connector. On top of it are the + and the -. Match them with the + and the of the LED strip. Slip the latter under the provided notches. The contact points of the strip (copper-colored marks) must touch the connector's tabs. Close the small valve and that's all there is to it. The electric connection is made.
Data sheet
- Range
- LED
- Input connection
- Quick connector 8 mm
- Output connection
- Male Jack
- Type of accessory
- Connector
- Total length
- 17cm